ADTRAN 1200214L1 Especificaciones descargar pdf (Pagina 96)

Chapter 8. Dial Backup Configuration

8-6 IQ Probe User Manual 61200214L1-20

If set to E

NABLED

, each DBU

NACTIVE

option applies.

If set to D

ISABLE

, each DBU

NACTIVE

option is disabled. See Configuring

the DCE Port on page 7-1.

DBU Timers

Fail Timer (FAIL TMR x 10)

This option sets the amount of time the dedicated circuit failure condition

must be active before the IQ Probe attempts backup. The value entered is

multiplied by 10. The amount of time can be up to 990 seconds (i.e., an en-

try of 99). The factory default setting is 10 seconds (an entry of 1).

Restore Timer (RESTORE TMR)

Once the circuit is down, the IQ Probe remains in backup until the circuit

is active for the length of time specified for the restore timer. The selection

is entered in minutes (up to 255). If set to 0, the line must be restored man-

ually. The factory default setting is 1 minute.

Redial Counter

This option sets the number of times the IQ Probe redials the far end when

entering backup mode. The redial count, which is manually entered, can

be up to a maximum of 99 attempts. If the IQ Probe encounters a busy or

reorder, it attempts to establish the call the specified number of times. The

factory default setting is 5.

Redial Delay

This option works in conjunction with the preceding R

EDIAL

OUNTER

. It

selects the amount of time between redial attempts to connect the backup

line. The amount of time, which is manually entered, can be up to 99 sec-

onds. The factory default setting is 15 seconds.

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 175 176

Sin comentarios

ADTRAN 1200214L1 Especificaciones Pagina 96