ADTRAN 1200214L1 Especificaciones descargar pdf (Pagina 142)

Chapter 11. Testing

11-6 IQ Probe User Manual 61200214L1-20

Ping

Select P

ING

to send a ping request to a specific address. Ping testing is only

available when the ethernet port is enabled (CONFIG -> SYSTEM -> ETH-

ERNET PORT).

Address to Ping (PING ADDRESS)

Enter the IP address of the unit the IQ Probe is sending an echo request

(ping) to.

Start Ping

The S

TART

ING

command causes the IQ Probe to send ten ping requests

to the target station. At the end of the ten-ping test, the following results

are shown. During front panel operation, use the arrow keys to scroll

through the results.

Pings Transmitted (PINGS TX)

This field shows the number of pings sent (always 10).

Ping Responses (PINGS RX)

This field shows the number of responses received from the pinged de-

vice.

Min Response Time (MIN RESP TIME)

This field shows the shortest round-trip delay (in ms) of the received re-

sponses. Round-trip delay is counted from the time the ping is sent until

the response is received.

Max Response Time (MAX RESP TIME)

This field shows the longest round-trip delay (in ms) of the received re-

sponses. If a response is not received before the unit times out, the delay

is not calculated in.

Avg Response Time (AVG RESP TIME)

This field shows the average response time (in ms) based on all received

responses.

1 2 ... 137 138 139 140 141 142 143 144 145 146 147 ... 175 176

Sin comentarios

ADTRAN 1200214L1 Especificaciones Pagina 142