
Chapter 4. Applications
4-4 IQ Probe User Manual 61200214L1-20
Minimum System Configuration Requirements
The following options (all found in the S
YSTEM
portion of the C
ONFIGURA
-
TION
menu) are the minimum configuration requirements for establishing
out-of-band SNMP or Telnet access. Once these options are configured,
the unit may be accessed using SNMP/Telnet.
Control Port Mode
If necessary, select SLIP or PPP as the IQ Probe control port mode. If eth-
ernet is the interface type, this parameter does not affect setup.
IP Address
Enter the IQ Probe IP address.
Subnet Mask
Enter the subnet mask number assigned to the network formed by the IQ
Probe and the other FRAD/routers across the frame relay network. The
subnet mask is available from the network administrator.
Gateway IP Address (if required)
Enter the Gateway node IP address. This address is applicable only if the
IQ Probe and the network manager are connected through a Gateway
node. This address is available from the network administrator.
The next five settings are applicable for SNMP access only:
Read Community
Set the R
EAD
C
OMMUNITY
name to match the NMS (network management
system) settings.
Write Community
Set the W
RITE
C
OMMUNITY
name to match the NMS settings.
Trap Manager DLCI
Identify the virtual circuit used for all traps generated by the IQ Probe.
This selection is found under T
RAP
M
GR
O
PTIONS
in the S
YSTEM
portion of
the C
ONFIGURATION
menu.
Comentarios a estos manuales