ADTRAN Stub Routing Especificaciones descargar pdf (Pagina 349)

100

101

Command Reference Guide DSX-1 Interface Configuration Command Set

DSX-1 INTERFACE CONFIGURATION COMMAND SET

To activate the DSX-1 Interface Configuration command set, enter the interface t1 command (and specify

the DSX-1 port) at the Global Configuration Mode prompt. For example:

Router>

enable

Router#

configure terminal

Router(config)#

interface t1 1/2

Router(config-t1 1/2)#

The following commands are common to multiple command sets and are covered in a centralized section

of this guide. For more information, refer to the sections listed below:

alias <“text”> on page 556

description on page 557

do on page 558

end on page 559

exit on page 560

shutdown on page 561

All other commands for this command set are described in this section in alphabetical order.

coding [ ami | b8zs ] on page 350

framing [ d4 | esf ] on page 351

line-length <value> on page 352

loopback network [ line | payload ] on page 353

loopback remote line inband on page 354

remote-loopback on page 355

signaling-mode [ message-oriented | none | robbed-bit ] on page 356

snmp trap line-status on page 357

snmp trap link-status on page 358

test-pattern [ones | zeros] on page 359

1 2 ... 344 345 346 347 348 349 350 351 352 353 354 ... 567 568

Comentarios a estos manuales

Sin comentarios

ADTRAN Stub Routing Especificaciones Pagina 349

Comentarios a estos manuales

Relacionado con productos y manuales para Redes ADTRAN Stub Routing