
Enable Mode Command Set Command Reference Guide
116 © 2003 ADTRAN, Inc. 61950860L1-35D
show ip protocols
Use the show ip protocols command to display IP routing protocol parameters and statistics.
Syntax Description
No subcommands
Default Values
No default value necessary for this command.
Command Modes
# Enable Command Mode
Command History
Release 3.1 Command was introduced
Usage Examples
The following is a sample output from the
show ip protocols
command:
>
enable
#
show ip protocols
Sending updates every 30 seconds, next due in 8 seconds
Invalid after 180 seconds, hold down time is 120 seconds
Redistributing: rip
Default version control: send version 2, receive version 2
Interface Send Ver. Rec Ver.
eth 0/1 2 2
ppp 1 2 2
Routing for networks:
1.1.1.0/24
Comentarios a estos manuales