ADTRAN 1204006L1 Manual de usuario descargar pdf (Pagina 93)

Chapter 7. DTE Port Configuration

61200208L1-1 Express 5210 User Manual 7-17

Physical Layer Options (PHYS LYR OPTS)

Interface Type (INTERFACE)

Select the connector type for the

DTE interface. The choices are

EIA-232

and

V.35

Bit Rate

Select the operating speed of the DTE interface.

TD Clock Source (TD CLOCK SRC)

Set clock source to

NTERNAL

XTERNAL

Transmit Idle Code (TX IDLE CODE)

Enable the Express 5210 to transmit

LAGS

or all

NES

Hardware Flow Control

When set to

, the Express 5210 varies the transmit clock rate to

temporarily limit the transmit data rate from the DTE device to the

Express 5210.

PPP Async Protocol

The

PPP A

SYNC

protocol functions the same as the

PPP

YNCHRONOUS

protocol except the port is in async format,

connected to an async device. Special control characters are used to

determine frame boundaries for the async channel.

See Figure 7-9

for the

PPP A

SYNCHRONOUS

menu tree.

Routing

Routing tables are formed through a combination of RIP and static

route entries. If RIP is used, all routing tables are generated

dynamically. With static routing, the user is able to force

relationships. Static routing requires additional configuration (see

the chapter IP Setup on page 12-1 for more information).

The bit rate selections vary depending on the speed selections made for the

network port. Also, for rates higher than 56/64 kbps, the External DCE

card is required.

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 202 203

Comentarios a estos manuales

Sin comentarios

ADTRAN 1204006L1 Manual de usuario Pagina 93

Comentarios a estos manuales

Relacionado con productos y manuales para Redes ADTRAN 1204006L1