ADTRAN 1204006L1 Manual de usuario descargar pdf (Pagina 111)

Chapter 9. Network Port Configuration

61200208L1-1 Express 5210 User Manual 9-7

LLC2 Busy Timeout (BUSY TO)

Length of time the LLC2 protocol will wait for a remote device to

clear a busy state before querying it with an RR (receiver ready)

command.

LLC2 Reject Timeout (REJECT TO)

Maximum time the LLC2 protocol will wait for a reject response

after issuing a reject command.

LLC2 Keep-Alive Timeout (KA TO)

Optional tool for detecting the status of an LLC2 connection.

Priority Queue Ratio (N:1) (QUEUE RATIO)

Define the ratio that SDLC frames have over other protocols. SDLC

protocols are processed each time the network port transmitter is

serviced. Other protocols are processed every N times the SDLC

protocol is processed. Set to 1 to enable equal priority.

PVC Options (PVC CONFIG)

The

PVC O

PTIONS

table is used to re-map incoming DLCIs during

dial backup applications. Normally, when an Express 5210 sends

data on a particular DLCI, the frame relay switch maps that DLCI

to the appropriate DLCI at the far end. During dial backup, the

frame relay switch no longer exists in the data path, so the mapping

must be done at the receiving end of the data path.

DLCI

Enter the

DLCI

that data is received on during non dial backup

periods (local DLCI). For an example of this setup, see Figure 9-3.

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 202 203

Sin comentarios

ADTRAN 1204006L1 Manual de usuario Pagina 111