ADTRAN 1204006L1 Manual de usuario Pagina 38

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 203
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 37
Chapter 3. Menu Navigation
3-2 Express 5210 User Manual 61200208L1-1
VT 100 Terminal Connection and Operation
To control the Express 5210 using a VT 100 terminal, perform the
following procedure:
1. Set the Express 5210 baud rate to match the terminal through
the front panel (default rate is 9600 bps). Select
1
C
ONFIG
, then
C
ONTROL
P
ORT
.
2. Using the provided VT 100 terminal adapter cable, connect the
COM port of a VT 100 compatible terminal or equivalent to the
eight-pin modular jack labeled
CONTROL on the rear of the
Express 5210. This connection is used for both local and remote
configuration.
3. Open the connection and press the terminal keyboard's
Enter
key repeatedly until the first menu appears.
4. Pressing any key selects
L
OCAL
L
OGIN
, which is used to
configure the Express 5210 unit connected to the terminal.
Pressing ^R (Ctrl R) selects
R
EMOTE
L
OGIN
, which is used to
configure a remotely located Express 5210 unit. For remote
applications, enter the
DLCI
(data link connection identifier) of
the remote unit at the prompt. Then press
Enter.
5. Enter the password. The factory default password is
adtran (all
lower-case). The main menu will appear, as shown in Figure
3-1.
In the lower left-hand corner of the terminal screen,
L
,
R
,
or
T
is dis-
played, indicating the type of interface the current screen represents (lo-
cal, remote, or TELNET).
When using Microsoft Hyperterminal, set the
F
ONT
to
T
ERMINAL
.
Vista de pagina 37
1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 202 203

Comentarios a estos manuales

Sin comentarios