ADTRAN 1204006L1 Manual de usuario descargar pdf (Pagina 35)

Chapter 2. Installation

61200208L1-1 Express 5210 User Manual 2-5

10BaseT LAN Connector

The LAN port is an 8-pin modular connector that provides a

10BaseT ethernet LAN interface. This interface is used for SNMP

and TELNET management and can also route non-management

data to any of the IP addresses known to the Express 5210. When

illuminated, the

Link LED (located on the rear panel) indicates

proper connection to a 10BaseT hub. The pin assignments for this

connector are listed in Table A-3 of the appendix Pinouts.

DTE Connectors

Connect a DTE device to the DTE connector using either an EIA-232

DTE cable or an ADTRAN V.35 DTE adapter cable. The maximum

cable lengths recommended are 50 feet for the EIA-232 and 100 feet

for the V.35. The pin assignments are listed in Table A-4 of the

appendix Pinouts.

The V.35 adapter cable is recommended for use with data rates

above 19.2 kbps. A low capacitance EIA-232 cable works up to

56 kbps. The DTE port is configured through the front panel or the

VT 100 control port and can operate in asynchronous or

synchronous mode. V.35 pin assignments are given in Table A-5 of

the appendix Pinouts.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 202 203

Sin comentarios

ADTRAN 1204006L1 Manual de usuario Pagina 35