
Chapter 12. IP Setup
61200208L1-1 Express 5210 User Manual 12-9
Network Name Entries
Logical network interfaces appear in the
N
ETWORK
N
AME
field in
one of the following ways:
• Through configuration of the DTE port.
When setting up the DTE port for
SDLC
,
T
RANSPARENT
BOP
, or
T
RANSPARENT
A
SYNC
protocol, the
O
UTGOING
DLCI
field identifies
a logical network interface.
• Through configuration of the network port.
When setting up the
PVC O
PTIONS
table under
N
ETWORK
C
ONFIGURATION
, setting
IP I
NTERFACE
to
E
NABLED
identifies a
logical network interface for that entry’s DLCI.
• Through the frame relay network.
DLCIs are learned through full status messages received from the
frame relay switch.
The only way to delete items from the
N
ETWORK
N
AME
field is
through the
N
ETWORK
C
ONFIGURATION
menu (
C
ONFIGURATION
->
N
ETWORK
->
PVC O
PTIONS
->
IP I
NTERFACE
). Set
IP I
NTERFACE
to
D
ISABLED
to delete the entry for the related DLCI. See the section
IP Interface on page 9-9 for more information.
RIP Selections
Selections in this menu vary depending on selections made for
M
ODE
. See the following charts:
Selections available for RIP M
ODE
option
Mode
Select
M
ODE
to configure RIP for this virtual circuit.
T
X
O
NLY
: RIP advertisements are periodically transmit-
ted, but received RIP packets are not processed.
R
X
O
NLY
: RIP advertisements are not transmitted, but
received RIP packets are processed.
T
X
AND
R
X
: RIP advertisements are periodically trans-
mitted, and received RIP packets are processed.
Comentarios a estos manuales