
Section 4 SHDSL RCU ATM User Interface Guide Total Access 544R System Manual
64 © 2003 ADTRAN, Inc. 61200704L2-1B
L2 PROTOCOL (ETH) > INTERFACE
Displays the interface type.
L2 PROTOCOL (ETH) > PROTOCOL
Displays the L2 protocol for the 10/100BaseT Ethernet port. Currently only 802.3 is supported.
L2 PROTOCOL (ETH) > CONFIG
Configure the mode for this 10/100BaseT Ethernet port from this menu.
L2 PROTOCOL (ETH) > CONFIG > MODE
The mode identifies how the data will be forwarded. The choices are:
The default is ROUTE IP.
L2 PROTOCOL (ETH) > STATUS
View the L2 protocol statistics for the 10/100BASET Ethernet port from this menu.
L2 PROTOCOL (ETH) > STATUS > TX PACKETS
Total number of packets transmitted out the Ethernet port.
L2 PROTOCOL (ETH) > STATUS > RX PACKETS
Total number of packets received from the Ethernet port.
L2 PROTOCOL (ETH) > STATUS > TX ERRORS
Total number of transmit errors encountered on Ethernet port.
L2 PROTOCOL (ETH) > STATUS > SINGLE COLLISIONS
Total number of single collisions before successful transmission.
L2 PROTOCOL (ETH) > STATUS > MULTIPLE COLLISIONS
Total number of multiple collisions before successful transmission.
ROUTE IP
All IP data will be routed
BRIDGE ALL
All data will be bridged
ROUTE IP/BRIDGE
OTHER
All IP data will be routed. All other data will be bridged.
Comentarios a estos manuales