ADTRAN TA 544 Manual de instrucciones descargar pdf (Pagina 60)

Section 4 SHDSL RCU ATM User Interface Guide Total Access 544R System Manual

L2 PROTOCOL (SHDSL - ATM) > CONFIG > PVC CONFIG > CONNECTION [ROUTER] > SETUP

> MODE

This mode identifies how the data will be transferred. The choices are:

The default is

ROUTE IP.

L2 PROTOCOL (SHDSL - ATM) > STATUS > ATM STATUS

AP: TX CELLS

This is the number of cells transmitted.

MAX FAILURE

Due to the nature of PPP, configuration option may not be agreed upon between two PPP peers. This

value is the number of configuration-naks that should occur before an option is

configuration-rejected. The possible values are

5 (DEFAULT), 10, 15, and 20.

FORCE PEER IP ADDRESS

This option forces the PPP to negotiate the IP address entered instead of allowing another address to

be assigned by the remote end. The default is

NO.

KEEPALIVE PERIOD

This option allows the user to generate PPP keepalive packets that can be sent every 1 minute, 2

minutes, or every

5 minutes. A value of 0 (OFF) disables the PPP keepalive packet generating feature.

The default is

0 (OFF).

PPP ENCAPSULATION

This option allows the user to set the encapsulation modes for PPP over ATM. LLC has an

encapsulation header in the AAL5 frame indicating it is encapsulating PPP. VC-Mux does not have a

header, and is therefor dedicated to using PPP. The choices are

LLC or VC-MUX. The default is

VC-MUX.

ROUTE IP

All IP data for this PVC will be routed.

BRIDGE ALL

All data for this PVC will bridged.

ROUTE IP/BRIDGE

THER

All IP data will be routed. All other data will be bridged.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 161 162

Sin comentarios

ADTRAN TA 544 Manual de instrucciones Pagina 60