ADTRAN TA 544 Manual de instrucciones descargar pdf (Pagina 58)

Section 4 SHDSL RCU ATM User Interface Guide Total Access 544R System Manual

L2 PROTOCOL (SHDSL - ATM) > CONFIG > PVC CONFIG > ACTIVE

Activates the ATM PVC. The choices are YES or NO. Default is NO.

L2 PROTOCOL (SHDSL - ATM) > CONFIG > PVC CONFIG > SUB-INTERFACE

The SHDSL Sub-Interface is ATM that represents the SHDSL physical and logical ports respectively. This

is a read-only field.

L2 PROTOCOL (SHDSL - ATM) > CONFIG > PVC CONFIG > VPI

ATM Virtual Path Identifier located in the ATM cell header identifies the virtual path over which this port

is running. The range is

0-256. The default is 0.

L2 PROTOCOL (SHDSL - ATM) > CONFIG > PVC CONFIG > VCI

This is the ATM Virtual Channel Identifier that serves as an address for the virtual channel cell

transmissions between two devices. The range is

0-6535. The default setting is 38.

L2 PROTOCOL (SHDSL - ATM) > CONFIG> PVC CONFIG > CONNECTION

Select the physical and logical method of data transfer over the virtual path.

L2 PROTOCOL (SHDSL - ATM) > CONFIG > PVC CONFIG > CONNECTION [ROUTER] > SETUP

> PROTOCOL

Select the data-link protocol for the PVC. The choices are IP or PPP. The default is IP.

The following PPP SETUP menu options only appear when the Protocol is set to PPP.

L2 Protocol > Config > PVC Config > Setup > PPP Setup.

AUTHENTICATION [+]

The AUTHENTICATION menu contains the required parameters for the authentication of the PPP peer

and for being authenticated by the PPP peer. Authentication is applied between the unit and the PPP

peer as described in the

AUTHENTICATION submenus.

TX METHOD

This parameter specifies how the unit is to be authenticated by the PPP peer. There are four possible

selections. Default it

NONE.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 161 162

Sin comentarios

ADTRAN TA 544 Manual de instrucciones Pagina 58