ADTRAN TA 544 Manual de instrucciones descargar pdf (Pagina 109)

DLP-4 Setting Ethernet IP Parameters

Introduction

If the unit is connected to an IP network for Telnet, TFTP, or SNMP management, several IP parameters

must be set for the unit to communicate with the network. These parameters are described in this DLP

along with the procedures for setting them.

Prerequisite Procedures

This procedure assumes that the unit is connected to an IP network and is powered up.

Tools and Materials Required

• VT100 compatible terminal or computer with terminal emulation software

• Appropriate cable to connect terminal to the unit (customer-provided)

• DB-9 female to RJ-45 female adapter for connecting to the CRAFT port on the rear of the unit. This

adapter is ADTRAN-proprietary and is provided with the unit.

• Ethernet cable from the 10/100BASET port on the unit to a hub (customer-provided)

• Use Ethernet crossover if going from the unit to a PC (customer-provided).

Please see your Network Administrator for the proper assignment of the following

parameters:

IP ADDRESS, SUBNET MASK, and DEFAULT GATEWAY.

To prevent electrical shock, do not install equipment in a wet location or during a

lightning storm.

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 161 162

Sin comentarios

ADTRAN TA 544 Manual de instrucciones Pagina 109