Application Views Adtran TSU IQ+ Configuration Application (AdTSUIQPConApp)
Device Management Page 79 Adtran DSU/CSU
IQ management data and is not passed to the
attached frame relay DTE device.
DLCI 2 Mode
Sets the mode for the management DLCI 2. If set
for shared, management DLCI 2 is used for
customer data and IQ management data. If set for
dedicated, management DLCI 2 is used only for
IQ management data and is not passed to the
attached frame relay DTE device.
DLCI 1 PVC 1 Address
Sets the address for management PVC 1 (Range
16 - 1007).
DLCI 2 PVC 2 Address
Sets the address for management PVC 2 (Range
16 - 1007).
Frame Relay Monitoring Configuration
History Intervals
Sets the number of history intervals for storage.
History Intervals Available
Returns the number of history intervals allowed
based on the maximum number of PVCs selected.
Sampling Rate
Allows you to set the sampling rate for frame relay
monitoring. Options are min5, min10, min15,
min20, and min30.
Maximum PVC supported
Sets the maximum PVCs supported by the IQ unit
(Range 1 - 100).
DSX Port Configuration View
Access: From the Icon Subviews menu for the
AdTSUIQPConApp, select DSX Port Configuration.
This view displays the following information.
Port Frame Type
Frame type for DSX interface. Either d4 or eSF.
Port Line Code
Line code for the DSX interface. Either b8ZS or
aMI.
Yellow Alarm Option
This option controls the origination of Yellow
alarm in case of framing loss on the receive side of
the DSX interface.
Port Line Build Out
Line build out for the transmit side of the DSX
interface. Possible values are dB0, dB7,dB15, and
db22.
Robbed Bit Signaling
Set for enabled if robbed bit signaling is used on
the DSX interface.
Comentarios a estos manuales