ADTRAN TSU 120 Especificaciones Pagina 59
- Pagina / 128
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Application Views Adtran IQ Probe Configuration Application (AdIQProbConApp)
Device Management Page 59 Adtran DSU/CSU
Signaling Response
Determines how the IQ device will respond to
polls from the DTE device during a network
failure. If set to alwaysOn, the IQ will respond to
polls during a network failure. If set to
followsNetwork, the IQ will not respond thus
emulating a failure to the DTE device. If the IQ is
responsible for dial backup, this option should be
set to alwaysOn. The other option is alwaysOff.
DBU Configuration View
Access: From the Icon Subviews menu for the
AdIQProbConApp icon, select DBU Configuration.
This view displays the following information.
DBU Option
This option specifies whether the unit
automatically enters dial backup mode or waits
for manual setup.
DBU Mode
This option specifies the dial backup operating
mode for the unit as originate or answer. One end
must be set to originate and the other end to
answer.
Carrier Detect Loss
This option enables the unit to enter backup
mode when loss of Carrier Detect on the DCE
interface occurs.
Loss of LMI Option
This option enables the unit to enter backup
mode when network PVC signaling state goes
down.
Answer Always
This option enables or disables Answer Always for
Dial Backup operation. If enabled, the answer
unit answers any incoming call regardless of
failed conditions.
Beeper Option
This option enables or disables the audible alarm
when the IQ unit goes into dial backup mode.
Pass Check
This option allows the unit to send and verify a
dial backup passcode for an additional level of
security. When enabled, the originate unit sends
the passcode and the answer unit checks the
passcode before the backup connection is
considered valid.
Pass Code
This option sets the dial backup passcode used to
provide an additional level of security. A passcode
of one to ten digit characters can be set. If
enabled, the originate unit sends the passcode
and the answer unit checks the passcode to verify
the connection.
- Adtran DSU/CSU 1
- Contents 3
- Contents Contents 4
- Introduction 7
- Supported Devices 8
- The SPECTRUM Model 9
- Figure 1: Device Icons 10
- Device View 14
- Interface Icons 15
- Interface Icon Subviews Menu 16
- Chassis Device View 17
- Chassis Module Icons 18
- Device Topology Views 20
- Sub-Interfaces Topology View 21
- DevTop Chassis View 21
- Application Views 22
- Supported Applications 23
- Device-Specific Applications 24
- Adtran Frame Relay 26
- Performance Application 26
- (AdFRPerformApp) 26
- Daily PVC Status Table View 32
- Daily Port Status Table View 34
- Daily Port Error Table View 35
- Daily History Time Table View 36
- Adtran DS1 Application 37
- (AdtranDS1App) 37
- Alert Table View 38
- Adtran DS1 Current Threshold 40
- Information View 40
- Adtran DS1 Total Threshold 41
- Adtran DSU IQ Configuration 42
- (AdDSUIQConApp) 42
- Trap Manager Table View 43
- DDS Interface Configuration 44
- Management DLCI Configuration 44
- DTE Port Configuration View 45
- PVC Configuration Table View 46
- Adtran DSU IQ Status 49
- (AdDSUIQStatApp) 49
- DDS Daily Status Table View 51
- DBU Daily Status Table 53
- Diagnostic Table View 54
- (AdIQProbConApp) 55
- DCE Port Configuration View 56
- Adtran IQ Probe Status App 61
- (AdIQProbStaApp) 61
- DBU Daily Status Table View 63
- DCE Daily Status Table View 65
- Adtran TSU IQ Configuration 66
- (AdTSUIQConApp) 66
- Adtran TSU IQ Status 71
- Application (AdTSUIQStatApp) 71
- T1 Interval Status Table View 72
- T1 Daily Status Table 73
- Adtran TSU IQ+ Configuration 77
- (AdTSUIQPConApp) 77
- DSX Port Configuration View 79
- Adtran TSU IQ+ Status 80
- (AdTSUIQPStaApp) 80
- T1 Daily Status Table View 82
- DSX Daily Status Table View 87
- Adtran DSU IV Application 88
- (AdDSUIVApp) 88
- DSU IV Status View 89
- Value Meaning 90
- ISDN Dial Backup Options 96
- DTE Configuration View 97
- Dial Configuration View 98
- Adtran TSU 600e Application 99
- (AdTSU600eApp) 99
- TSU 600e Configuration View 100
- Adtran TSU 120e Application 101
- (AdTSU120eApp) 101
- Adtran Smart 16 Application 102
- (AdSmart16App) 102
- Adtran TSU ESP Application 103
- (AdTSUESPApp) 103
- TSU ESP Status View 104
- Test Operation View 105
- Dial Operation View 106
- Unit Configuration View 106
- Network Configuration View 107
- DBU Configuration View 108
- ISDN DBU Configuration View 109
- Port Configuration View 110
- Adtran Administrative 111
- Application 111
- (AdtranAdminApp) 111
- Adtran ATLAS Chassis 111
- Application (AdATLChasApp) 111
- Interface Table 112
- Physical Table 112
- Adtran ATLAS General Option 113
- Card Application 113
- (AdATLGenOCApp) 113
- Adtran ATLAS Front Panel 114
- Group Application 114
- (AdATLFrPnlApp) 114
- State Status 115
- Module LED Table 116
- Adtran ATLAS V35Nx4 117
- (AdATLV35Nx4App) 117
- Performance Views 119
- Configuration Views 120
- DLCI_Port Configuration View 121
- Adtran Product View 122
- Channel Unit Information 123
- Model Information View 124
- Index Index 128
© 2020, manymanuals.es. Todos los derechos reservados | 0.028 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales