ADTRAN TSU 120 Especificaciones Pagina 69

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 128
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 68
Application Views Adtran TSU IQ Configuration Application (AdTSUIQConApp)
Device Management Page 69 Adtran DSU/CSU
Error Window, N393
Sets the error window (polling events) for the
frame relay management (Range 1 - 10).
Signaling Response
Determines how the IQ device will respond to
polls from the DTE device during a network
failure. If set to alwaysOn, the IQ will respond to
polls during a network failure. If set to
followNetwork, the IQ will not respond thus
emulating a failure to the DTE device. If the IQ is
responsible for dial backup, this option should be
set to alwaysOn.
DBU Configuration View
Access: From the Icon Subviews menu for the
AdTSUIQConApp, select DBU Configuration.
This view displays the following information.
DBU Option
This specifies whether the unit automatically
enters dial backup mode or waits for manual
setup.
DBU Mode
This option specifies the dial backup operating
mode for the unit as originate or answer. One
must be set to originate and the other end to
answer.
Network Failure Option
This option enables the unit to enter backup
mode when T1 network failure occurs.
Loss of LMI Option
This enables the unit to enter backup mode when
the network PVC signaling state goes down.
Answer Always
This enables or disables Answer Always for Dial
Backup operation. If enabled, the answer unit
answers any incoming calls regardless of failed
conditions.
Beeper Option
This option enables or disables the audible alarm
when the IQ unit goes into dial backup mode.
Pass Check
This allows the unit to send and verify a dial
backup passcode for an additional level of
security. When enabled, the originate unit sends
the passcode and the answer unit checks the
passcode before the backup configuration is
considered valid.
Pass Code
This sets the dial backup passcode used to
provide an additional level of security. A passcode
of 1 to 10 digit characters can be set. If enabled,
the originate unit sends the passcode and the
Vista de pagina 68
1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 127 128

Comentarios a estos manuales

Sin comentarios