Application Views Adtran TSU IQ Status Application (AdTSUIQStatApp)
Device Management Page 71 Adtran DSU/CSU
condition occurs. Redial count can be set for a
maximum of 60.
Auto Restore Timer
This option selects the amount of time that the
DSUIQ circuit must be active before the unit
switches from backup to normal mode of
operation. The timer value is in minutes from 0 to
60. A zero value disables the automatic restore.
ISDN Switch
This option is used to select the ISDN switch type.
Types are att-5ess and nt-dms-100.
ISDN Channel Rate
This option is used to select the ISDN channel
rate.
ISDN SPID 1
This option is used to set the Service Provider ID
(SPID) for the ISDN interface.
ISDN SPID 2
This option is used to set the SPID for the ISDN
interface.
ISDN LDN 1
This option is used to LDN for the ISDN interface.
ISDN LDN 2
This option is used to set LDN for the ISDN
interface.
Adtran TSU IQ Status
Application (AdTSUIQStatApp)
This application has the following available
application-specific subviews:
• Current Status View
• T1 Interval Status Table View (Page 72)
• T1 Daily Status Table (Page 73)
• DBU Interval Status Table View (Page 74)
• DBU Daily Status Table (Page 76)
• Diagnostic Table View (Page 54)
Current Status View
Access: From the Icon Subviews menu for the
AdTSUIQStatApp, select Current Status.
This view displays the following information.
T1 State
Current status of the T1 interface. Possible values
are openLoop, testFromTelco, blueAlarm,
redAlarm, yellowAlarm, eSFNormal, and
d4Normal.
DBU State
The current state of the DBU interface. Possible
states are emptySlot, openLoop, gettingTEI,
tEIOK, sPIDOK, idle, inDBU, waitingForCall,
Comentarios a estos manuales