ADTRAN ATLAS 800PLUS Manual de usuario Pagina 150
- Pagina / 210
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Chapter 12. SNMP Management
12-4 ATLAS 800
PLUS
User Manual 61200226L1-1
When enabled, ATLAS 800
PLUS
sends alarm traps to the each member of the
trap destination list upon detecting status bit changes in dsx1LineStatus. Each
status change sets an event bit = 1 in the adDS1LineEvent variable in the DS1
alarm table. If you have previously set the corresponding enable bit = 1 in
the adDS1LineArm variable and adDS1AlarmEnable = On, then
ATLAS 800
PLUS
sends an alarm trap message. A single alarm trap message
may report multiple event changes. ATLAS 800
PLUS
clears the event bits af-
ter sending the trap message or sending the response to a Get request for the
adDS1LineEvent variable.
DS1 Alert Traps
RFC1406 also defines a series of Current and Total Alert threshold values.
You can enable ATLAS 800
PLUS
to send an alert trap message to each mem-
ber of the trap destination list when accumulated error statistics exceed
these threshold values. Table 12-4 describes the alert traps supported by
ATLAS 800
PLUS
for events that have occurred in the last 15-minute interval.
Table 12-3. DS1 SNMP Traps
Alarm Severity Description
adATLAS800NoAlarm
Warning No alarms are present.
adATLAS800RxYellow
Minor The Far end is experiencing Red Alarm
(a.k.a. Yellow Alarm).
adATLAS800TxYellow
Warning The Near end is sending Loss Frame Indication
(a.k.a. Yellow Alarm).
adATLAS800RxAIS
Minor The Far end is sending Alarm Indication Signal
(a.k.a. Blue Alarm).
adATLAS800TxAIS
Warning The Near end is sending Alarm Indication Signal
(a.k.a. Blue Alarm).
adATLAS800RedAlarm
Major The Near end is experiencing Loss of Frame
(a.k.a. Red Alarm).
adATLAS800LOS
Major The Near end is experiencing Loss of Signal.
Table 12-4. DS1 Current Alert SNMP Traps
Current Alert Severity Description
adATLAS800CurrentES
Warning The current interval errored second threshold has
been exceeded.
adATLAS800CurrentSES
Warning The current interval severely errored second
threshold has been exceeding.
adATLAS800CurrentSEFS
Warning The current interval severely errored framing second
threshold has been exceeded.
- ATLAS 800 1
- TRADEMARKS 2
- LIMITED PRODUCT WARRANTY 9
- About this Manual 10
- Table of Contents 13
- User Manual xv 15
- User Manual xvii 17
- User Manual xix 19
- User Manual xxi 21
- List of Figures 23
- List of Tables 25
- Introducing the ATLAS 800 27
- 1-2 ATLAS 800 28
- User Manual 1-3 29
- 1-4 ATLAS 800 30
- User Manual 1-5 31
- FEATURES 32
- User Manual 1-7 33
- 1-8 ATLAS 800 34
- Installing the ATLAS 800 35
- AC Powered Unit 36
- DC Powered Unit 36
- GROUNDING INSTRUCTIONS 36
- REVIEW THE REAR PANEL DESIGN 37
- Control/Chain In Port 38
- Control/Chain Out Port 39
- Network Connection 40
- Ethernet 10BaseT Connection 41
- Option Slots 41
- INSTALL ANY OPTION MODULES 42
- POWER-UP 42
- Operating the ATLAS 800 43
- USING THE TERMINAL MENU 44
- Using Telnet 45
- 3-4 ATLAS 800 46
- Using T-Watch PRO 47
- 3-6 ATLAS 800 48
- Using the Front Panel 49
- 4-2 ATLAS 800 50
- User Manual 4-3 51
- 1) STATUS 3) UTIL 52
- 2) CONFIG 4) ALRM 52
- User Manual 4-5 53
- FRONT PANEL MAIN MENU 54
- » S0 System 55
- 4-8 ATLAS 800 56
- » Time/Date 57
- » Software Rev 57
- » Selftest 58
- » Set Passcode 59
- » Password Reset 59
- » Active Alarms 59
- » View History 60
- » Clear History 60
- Navigating the Terminal Menu 61
- Window Panes 62
- Moving through the Menus 63
- Session Management Keystrokes 64
- Configuration Keystrokes 64
- Getting Help 65
- 5-6 ATLAS 800 66
- Terminal Menu and System 67
- User Manual 6-3 69
- » Event Log 70
- » Clear System 70
- Event Log 70
- User Manual 6-5 71
- » Configuration 72
- » Trunk Usage 72
- » Data Tables 72
- » Chain Port Signal 72
- User Manual 6-7 73
- INTERNAL 73
- INTERNAL 73
- » Session Timeout 74
- » Max Telnet 74
- Sessions 74
- » Ethernet Port 74
- » Chain Port 74
- » System Event 76
- » Syslog Setup 76
- » Real Time Clock 76
- » Access Passwords 77
- » Bonding Config 78
- » Update Firmware 79
- » Update Status 82
- » Config Transfer 82
- » System Utilization 83
- » System Selftest 83
- 6-18 ATLAS 800 84
- User Manual 6-19 85
- » Reboot System 86
- » Factory Default 86
- Modules Terminal Menu 87
- » Status 89
- 7-4 ATLAS 800 90
- User Manual 7-5 91
- 7-6 ATLAS 800 92
- User Manual 7-7 93
- 7-8 ATLAS 800 94
- Dedicated Maps Terminal 95
- » Activate Time 99
- » Enbl Day 99
- Configuring the Ports 101
- Defining the Connections 102
- 61200226L1-1 ATLAS 800 103
- User Manual 8-9 103
- 8-10 ATLAS 800 104
- User Manual 61200226L1-1 104
- OVERVIEW 105
- Chapter 9 105
- » Submenus 106
- INTERFACE CONFIGURATION 107
- 9-4 ATLAS 800 108
- CIRCUIT STATUS MENU 109
- (MANUAL 109
- BKUP STATUS 110
- (BACKUP 110
- LINE STATUS 110
- » Last Run Time 111
- » Next Run Time 111
- » Last Test Status 111
- » Pass : Fail 111
- » Test Now 111
- 9-8 ATLAS 800 112
- Dial Plan Terminal Menu 113
- » Slot/Svc 115
- » Port/PEP 115
- » Out#Accept 115
- » Out#Rej 116
- » Ifce Config 117
- » Slot/Svc, Port/PEP 117
- » In#Accept 118
- 10-8 ATLAS 800 120
- » Automatic 121
- Routeback 121
- Rejection 121
- User Manual 10-11 123
- 10-12 ATLAS 800 124
- User Manual 10-13 125
- » Strip MSD 126
- » Network Specific 126
- Facility Voice 126
- Facility Data 126
- » ID Presentation 127
- » ID Number 127
- » Source ID 127
- 10-16 ATLAS 800 128
- » Caller ID Number 129
- 10-18 ATLAS 800 130
- User Manual 10-19 131
- 10-20 ATLAS 800 132
- CREATING DIAL PLANS—EXAMPLES 133
- Interface 134
- User Manual 10-23 135
- 10-24 ATLAS 800 136
- OUTGOING ACCEPT # 136
- Network Term 137
- Out#Accept and 137
- Slot 1/ Port 1 138
- User Manual 10-27 139
- 10-28 ATLAS 800 140
- Updating Firmware 141
- Restart 142
- Schedule 142
- Current Update Status 142
- User Manual 11-3 143
- Module Update Complete 143
- 11-6 ATLAS 800 146
- SNMP Management 147
- SNMP TRAPS 148
- Trap Destination List 148
- Filtering (Disabling) Traps 148
- Chapter 12. SNMP Management 149
- User Manual 12-3 149
- 12-4 ATLAS 800 150
- User Manual 12-5 151
- 12-6 ATLAS 800 152
- ADTRAN Utilities 153
- SysLog GUI 154
- Menu Bar 155
- » Erase Log Files 156
- » Define RED Events 156
- » Properties 156
- » Clear Red Events 156
- Chapter 13. ADTRAN Utilities 157
- User Manual 13-5 157
- » Connect 158
- » Disconnect 158
- User Manual 13-7 159
- User Manual 13-9 161
- » Contents 162
- PRINT LOG 163
- The ATLAS 800 166
- reboots immediately after a 166
- System Event Logging 167
- A-2 ATLAS 800 168
- User Manual A-3 169
- A-4 ATLAS 800 170
- User Manual A-5 171
- A-6 ATLAS 800 172
- User Manual A-7 173
- A-8 ATLAS 800 174
- User Manual A-9 175
- A-10 ATLAS 800 176
- User Manual A-11 177
- A-12 ATLAS 800 178
- User Manual A-13 179
- A-14 ATLAS 800 180
- Troubleshooting 181
- Misconfiguration 182
- Appendix B. Troubleshooting 183
- User Manual B-3 183
- B-4 ATLAS 800 184
- Warranty and Technical 185
- Support Information 185
- Repair and Return 186
- Acronyms and Abbreviations 187
- D-2 ATLAS 800 188
- Glossary 189
- Appendix E. Glossary 190
- E-2 ATLAS 800 190
- User Manual E-3 191
- E-4 ATLAS 800 192
- User Manual E-5 193
- E-6 ATLAS 800 194
- Numerics 195
- Index-2 ATLAS 800 196
- User Manual Index-3 197
- Index-4 ATLAS 800 198
- User Manual Index-5 199
- Index-6 ATLAS 800 200
- User Manual Index-7 201
- Index-8 ATLAS 800 202
- User Manual Index-9 203
- Index-10 ATLAS 800 204
- User Manual Index-11 205
- Index-12 ATLAS 800 206
- User Manual Index-13 207
- Index-14 ATLAS 800 208
- Product Support Information 209
Relacionado con productos y manuales para Redes ADTRAN ATLAS 800PLUS
Redes ADTRAN 6310 Información técnica
(40 paginas)
(40 paginas)
Redes ADTRAN 1202156L1 Manual de usuario
(132 paginas)
(132 paginas)
Redes ADTRAN TDU 120e Manual de usuario
(146 paginas)
(146 paginas)
Redes ADTRAN NxT1 HSSI/V-35 Manual de usuario
(48 paginas)
(48 paginas)
Redes ADTRAN 600 SERIES Manual de instrucciones
(74 paginas)
(74 paginas)
Redes ADTRAN Stub Routing Especificaciones
(568 paginas)
(568 paginas)
Redes ADTRAN E1 Manual de usuario
(36 paginas)
(36 paginas)
Redes ADTRAN 1200130L2 Manual de usuario
(153 paginas)
(153 paginas)
Redes ADTRAN SLC-5 U-BR1TE III Manual de usuario
(136 paginas)
(136 paginas)
Redes ADTRAN 1200263L1-1.2A Manual de usuario
(33 paginas)
(33 paginas)
Redes ADTRAN NetVanta 3205 Manual de usuario
(12 paginas)
(12 paginas)
Redes ADTRAN Express 6120 Manual de instrucciones
(161 paginas)
(161 paginas)
Redes ADTRAN Express 4120 Manual de usuario
(205 paginas)
(205 paginas)
Redes ADTRAN NetVanta 4305 Manual de usuario
(20 paginas)
(20 paginas)
Redes ADTRAN ISU 512 Manual de usuario
(129 paginas)
(129 paginas)
Redes ADTRAN Express 4100 Manual de usuario
(213 paginas)
(213 paginas)
Redes ADTRAN Tracer TRACER 2 x E1 Manual de usuario
(128 paginas)
(128 paginas)
Redes ADTRAN 1200350L1 Manual de usuario
(134 paginas)
(134 paginas)
Redes ADTRAN Tracer TRACER 2 x E1 Guía de usuario
(112 paginas)
(112 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.062 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales