ADTRAN 1200287L1 Manual de usuario descargar pdf (Pagina 27)

Chapter 2. Installation and Operation

61185001L1-1 MX2810 M13 User Manual 2-5

RACKMOUNT INSTALLATION

The MX2810 can be mounted into a standard 19-inch or 23-inch

equipment rack. Follow these steps to mount your unit into a rack:

1. Install the mounting flanges on each side of the MX2810 at one

of the three available positions.

2. After the flanges have been installed, position the MX2810 at

the correct location within the rack and secure the mounting

flanges to the mounting rails of the rack.

3. Make all network, DSX terminations, and power connections to

the rear of the unit. See Power Up on page 2-2 for more

information on making the DC power connection.

4. Connect a VT100 terminal device to the

CRAFT

port on the

front panel of the unit.

Connecting the Breakout Panel

The optional breakout panel (P/N 1200291L1) connects to the

MX2810 via the

and

OUT

Champ connectors located on the back

of the unit, and provides 28 RJ connectors for the individual T1s/

E1s. Shipment includes two six-foot, 64-pin to 64-pin Amp cables

which allow direct cabling to the MX2810. Connect the breakout

panel’s

Champ connector to the MX2810’s

Champ connector

and the breakout panel’s

OUT

Champ connector to the MX2810’s

OUT

Champ connector (see Figure 2-2)

Be sure to install the flanges with the screws provided.

Two MX2810s may be stacked with no spacing between units. ADTRAN

recommends 1U (1.75") of separation above and below the two stacked

units. This spacing allows the unit to dissipate heat. The design of the

MX2810 uses the chassis to distribute heat generated by the unit's

internal cards. This design allows the unit to operate without a cooling

fan, which increases the overall reliability of the unit.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 203 204

Sin comentarios

ADTRAN 1200287L1 Manual de usuario Pagina 27