ADTRAN 1200287L1 Manual de usuario descargar pdf (Pagina 134)

Chapter 9. Transaction Language 1 (TL1)

9-18 MX2810 M13 User Manual 61185001L1-1

An example of this command that would enable "all" autonomous

messages is:

ALW-MSG-ALL;

The response to this command would be:

Unit 1 01-10-15 10:34:21

M 0 COMPLD

;

Where

"Unit 1" is the <tid> defined in the menus,

"01-10-15 10:34:21" is the date and time,

"M 0 COMPLD" is the ctag and completion code.

Similarly, to enable just the T1 autonomous messages the following

command could be used:

ALW-MSG-T1;

In order to disable autonomous message reporting, the following

steps must be followed:

• Initiate a TL1 session by following the setup procedures and

using the ACT-USER command (if this has not been done.)

• Use the INH-MSG command to disable autonomous

messaging. This command is described in Table 2. The format

for the command is:

INH-MSG-{EQPT[rr]ALL};

Where

{ } means to use one of the following,

rr is either T1, T2, or T3.

An example of this command that would disable "all" autonomous

messages is:

INH-MSG-ALL;

The response to this command would be:

Unit 1 01-10-15 10:34:21

M 0 COMPLD

1 2 ... 129 130 131 132 133 134 135 136 137 138 139 ... 203 204

Sin comentarios

ADTRAN 1200287L1 Manual de usuario Pagina 134