ADTRAN Tracer TRACER 2 x E1 Manual de usuario descargar pdf (Pagina 73)

Table 4: Channelized E1 and Channelized E1 IQ show interfaces Output Fields (continued)

Level of OutputField DescriptionField Name

All levelsEncapsulation being used on the physical interface.Link-level type

All levelsMTU size on the physical interface.MTU

All levelsReference clock source: Internal or External.Clocking

All levelsSpeed at which the interface is running.Speed

All levelsWhether loopback is enabled and the type of loopback (local or remote).Loopback

All levelsFrame check sequence on the interface (either 16 or 32). The default is 16 bits.FCS

All levelsPhysical layer framing format used on the link. It can be G704, G704-NO-CRC4,

or Unframed. The default is G704.

Framing

All levels(Channelized E1 IQ interfaces only) Name and interface index of the interface

to which a particular child interface belongs. None indicates that this interface

is the top level.

Parent

All levelsInformation about the physical device. Possible values are described in the

“Device Flags” section under Common Output Fields Description.

Device flags

All levelsInformation about the interface. Possible values are described in the “Interface

Flags” section under Common Output Fields Description.

Interface flags

All levelsInformation about the link. Possible values are described in the “Link Flags”

section under Common Output Fields Description.

Link flags

detail extensiveCurrent interface hold-time up and hold-time down, in milliseconds.Hold-times

detail extensive none(PPP and HDLC) Configured settings for keepalives.

• Interval seconds—Time in seconds between successive keepalive requests.

The range is 10 seconds through 32,767 seconds, with a default of 10 seconds.

• Down-count number—Number of keepalive packets a destination must fail

to receive before the network takes a link down. The range is 1 through 255,

with a default of 3.

• Up-count number—Number of keepalive packets a destination must receive

to change a link's status from down to up. The range is 1 through 255, with a

default of 1.

Keepalive settings

Chapter 5: Monitoring Commands

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 127 128

Sin comentarios

ADTRAN Tracer TRACER 2 x E1 Manual de usuario Pagina 73