ADTRAN T200 FNID Especificaciones descargar pdf (Pagina 4)

4 61184002L3-5B

OPTI-3 WMC also provides two OCM slots, but the

slots are positioned so that one OCM is above the

other. The bottom slot is slot A and the top is slot B.

See Figure 5. Install the appropriate Total Access

OPTI-3 chassis before performing the OCM

installation. A Job Aid is shipped with each chassis.

The Job Aid provides information and installation

instructions concerning the Total Access OPTI-3

WMC or RMC respectively. The part number for the

WMC Job Aid is 61184001L1-22 and the part number

for the RMC Job Aid is 61184003L1-22.

Carefully insert the OCM approximately half way into

the selected slot. Route the fiber through the notch on

the front panel of the OCM and approximately 4

inches past the SC receptacles (this will create slack).

Continue to keep the slack in the fiber optic cable, and

make the connection by gently inserting the SC

connectors into the receptacles. See Figure 6.

Verify that the cable will not be pinched and then

gently push the OCM about three quarters of the way

into the slot. This will remove most of the slack in the

fiber optic cable. Make sure that the cable is situated

in such a manner that it will be free when the card is

removed.

WARNING

If power is connected to the chassis, once the

module is inserted fully into the chassis, it will be

powered.

Gently but firmly push the module all the way into the

chassis and push the latch/ejector tab toward the front

panel.

If installing into the RMC, route the fiber optic cable

from the notch in the OCM down the length of the

fiber routing tray to the innerduct, making sure that

the fiber is beneath the tabs.

When the OCM first powers up, it performs a self-test.

During the self-test, all of the front panel LEDs will

illuminate yellow for approximately 8 seconds. The

self-test is complete once the STATUS LED

illuminates GREEN, indicating a successful self-test.

At this point, the LEDs on the front panel reflect the

true state of the hardware.

Figure 5. OPTI-3 WMC

OPTI-3

ENABLE

TESTAPS ACO

1184002L3

CRAFT

STATUS

OPTICS

DS3-1

DS3-2

DS3-3

ACO

OPTI-3

ENABLE

TESTAPS ACO

1184002L3

CRAFT

STATUS

OPTICS

DS3-1

DS3-2

DS3-3

ACO

Slot B

(protect card)

Slot A

(working card)

Figure 6. Fiber Connection to the OPTI-3

OPTI-3

ENABLE

TESTAPS ACO

1184002L3

STATUS

OPTICS

DS3-1

DS3-2

DS3-3

ACO

1 2 3 4 5 6 7 8 9 ... 75 76

Comentarios a estos manuales

Sin comentarios

ADTRAN T200 FNID Especificaciones Pagina 4

Comentarios a estos manuales

Relacionado con productos y manuales para Redes ADTRAN T200 FNID