Adtran 1000R Series Manual de usuario descargar pdf (Pagina 30)

Command Reference Guide Common Commands

Step 2:

Create the sub-interface and configure the PVC parameters. Using the sub-interface, apply access policies to

the interface, create bridging interfaces, configure dial-backup, assign an IP address, and set the PVC data-link

control identifier (DLCI). For example, the following creates a Frame Relay sub-interface labeled

22,

sets the

DLCI to

30,

and assigns an IP address of

193.44.69.253

to the interface.

(config-fr 7)#

interface fr 7.22

(config-fr 7.22)#

frame-relay interface-dlci 30

(config-fr 7.22)#

ip address 193.44.69.253 255.255.255.252

Step 3: (VALID ONLY FOR T1 INTERFACES)

Specify the group of DS0s used for signaling on the T1 interface by creating a TDM group. Group any number of

contiguous DS0s together to create a data pipe for layer 2 signaling. Also use the

tdm-group

command to

specify the per-DS0 signaling rate on the interface. For example, the following creates a TDM group labeled

containing 20 DS0s (each DS0 having a data rate of 56 kbps).

(config)#

interface t1 1/1

(config-t1 1/1)#

tdm-group 9 timeslots 1-20 speed 56

(config-t1 1/1)#

exit

Step 4:

Make the association between the layer 2 endpoint and the physical interface using the

cross-connect

command. Supported layer 2 protocols include Frame Relay and point-to-point protocol (PPP). For example, the

following creates a cross-connect (labeled

) to make an association between the Frame Relay virtual interface

(

fr 7

) and the TDM group configured on interface t1 1/1 (

tdm-group 9

(config)#

cross-connect 5 t1 1/1 9 fr 7

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 136 137

Comentarios a estos manuales

Sin comentarios

Adtran 1000R Series Manual de usuario Pagina 30

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Adtran 1000R Series