ADTRAN Stub Routing Guía de usuario descargar pdf (Pagina 109)

CHAPTER 6

Command Summary

•

Ethernet Interface Operational Mode Commands on page 97

Ethernet Interface Operational Mode Commands

Table 8 on page 97 summarizes the command-line interface (CLI) commands that you

can use to monitor and troubleshoot aggregated Ethernet, Fast Ethernet, Gigabit Ethernet,

and 10-Gigabit Ethernet interfaces. Commands are listed in alphabetical order.

Table 8: Ethernet Interface Operational Mode Commands

CommandTask

clear auto-configuration interfacesClear dynamic VLAN interfaces.

clear auto-configuration interfaces interface-setClear a specified dynamic agent circuit identifier

(ACI) interface set configured on the router. You

can clear only those ACI interface sets that have

no subscriber interface members.

clear lacp statisticsClear Link Aggregation Control Protocol (LACP)

statistics.

clear lacp timeoutsClear Link Aggregation Control Protocol (LACP)

timeout entries.

clear interfaces mac-databaseClear learned MAC addresses from the

hardware and MAC database. Static MAC

addresses are not cleared.

clear interfaces mac-database statisticsClear statistics that are collected for every MAC

address, including policer statistics, on a given

physical or logical interface.

clear interfaces interface-set statisticsClear statistics that are collected for interface

sets.

clear oam ethernet

connectivity-fault-management

continuity-measurement

Clear the existing continuity measurement and

restart counting the operational uptime.

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 131 132

Sin comentarios

ADTRAN Stub Routing Guía de usuario Pagina 109