ADTRAN 1204006L1 Manual de usuario descargar pdf (Pagina 89)

61200.175L1-1 FSU 5622 ESP User Manual 73

Chapter 6. DTE Port Configuration

Slip Protocol

The Slip Protocol is an asynchronous protocol which encapsu-

lates and routes IP traffic to and from a SLIP device. Special

control characters are used to define frame boundaries. See

Figure 6-11 for the Slip menu tree.

Routing

Routing tables are formed through a combination of RIP and

static route entries. If RIP is used, all routing tables are gener-

ated dynamically. With static routing, the user is able to force

relationships. Static route tables are configured through the IP

Routing selection in the CONFIG menu.

Static routing requires additional configuration (see the chapter IP

Routing for more information).

Physical Layer Options

Interface Type (CONN)

Select the connector type for the DTE interface. The choices are

V.35 and EIA-232.

Asynchronous Bit Rate (BAUD)

Set the operating speed of the DTE interface to match the

connected device. The selections are 2400 bps, 4800 bps, 9600

bps, 19.2 kbps, and 38.4 kbps.

Data Bits

Set the byte length to match the connected asynchronous device.

The choices are 7 and 8.

Parity

Select even, odd, or no parity information. Set to match the

connected asynchronous device.

Stop Bits

Select one or two stop bits. Set to match the connected asyn-

chronous device.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 174 175

Sin comentarios

ADTRAN 1204006L1 Manual de usuario Pagina 89