
60 FSU 5622 ESP User Manual 61200.175L1-1
Chapter 6. DTE Port Configuration
Physical Layer Options
Interface Type (CONN)
Select the connector type for the DTE interface. The choices are
V.35 and EIA-232.
Synchronous Bit Rate (RATE)
Select the operating speed of the DTE interface. The selections
are 2400, 4800, and 9600 bps and 19.2, 38.4, 56, 64, 112, 128, 168,
192, 224, 256, 280, 320, 384, 448, and 512 kbps.
Speed selections made for the Network Port affect the choices available
for the DTE ports.
Transmit Idle Code (IDLE)
Enable the FSU 5622 ESP to transmit flags or all ones (flags are
recommended).
Hardware Flow Control (HDW FLOW CTRL)
When enabled, the FSU 5622 ESP varies the transmit clock rate to
temporarily limit the transmit data rate to the FSU 5622 ESP.
Protocol Options
Protocol options are not available when the Transparent BOP
protocol is enabled.
Protocol Address Table
Far End Port Number (FE PORT)
Enter the remote FSU 5622 ESP port number that the remote
HDLC device is connected to.
Outgoing DLCI (OUT DLCI)
Enter the DLCI address that indicates the virtual circuit used to
connect with the remote FSU 5622 ESP.
Comentarios a estos manuales