ADTRAN T1-FT1 Manual de usuario descargar pdf (Pagina 2)

2 Technical Support 1-888-4ADTRAN (1-888-423-8726) 61200862L1-42B

The NetVanta may be initially accessed and managed via a console session. Refer to Initiate a

Console Session for console session intructions.The default Ethernet port parameters allow the

NetVanta to be accessed using a hub and two Ethernet cables (one for the PC and one for the

router). The default Ethernet IP address is 10.10.10.1. Refer to Configure Telnet Access on page

6 to configure the Telnet session settings.

1. Connect a VT100 terminal (or PC with VT100 emulation software) to the NetVanta

CONSOLE port using a DB-9 (male) to DB-9 (female) straight-through serial cable.

2. Configure the COM port with the following parameters:

Data Rate: 9600

Data Bits: 8

Parity Bits: None

Stop Bits: 1

Flow Control: None

3. Open a VT100 terminal session. (Please refer to the appropriate VT100 terminal software

documentation for detailed instructions.)

4. Press the <Enter> key.

5. Enter enable at the > prompt.

6. Enter the password when prompted. The default password is password.

7. You are now at the # prompt. At the # prompt, enter config terminal to enter the Global

Configuration mode.

1. At the (config)# prompt, enter interface eth 0/1 to access the configuration parameters for

the Ethernet port located on the rear panel of the unit.

2. Enter ip address 10.10.20.7

255.255.255.0 to assign an IP address to the Ethernet port

using a 24-bit subnet mask.

3. Enter no shutdown to activate the interface to pass data.

4. Enter exit to exit the Ethernet interface commands and return to the Global Configuration

mode.

Configure the Unit

Initiate a Console Session

Configure the Ethernet Port Parameters

If you are accessing the NetVanta via Telnet, once you change this IP address, you will

lose connection to the router. You must change the IP address of your PC before you can

proceed.

ADTRAN recommends that you set the Ethernet speed and duplex to match the switch or

hub it is plugged in to.

For example: (config-eth 0/1)#speed 10

(config-eth 0/1)#half-duplex

1 2 3 4 5 6 7

Sin comentarios

ADTRAN T1-FT1 Manual de usuario Pagina 2