ADTRAN NetVanta 3000 Series Guía de instalación descargar pdf (Pagina 64)

Unit Installation NetVanta 3200/3300/3400 Series

Figure 29. Wall Mounting the NetVanta 3200

Instructions for Wall Mounting NetVanta 3200

Step Action

Decide on a location for the unit. Keep in mind that the unit needs to be mounted at or below eye level so

that the LEDs are viewable.

Prepare the mounting surface by attaching a board (typically plywood, 3/4-inch to 1-inch thick) to a wall

stud using #6 to #10 (2.5-inch or greater in length) wood screws.

Important! Mounting to a stud ensures stability. Using sheetrock anchors may not provide

sufficient long-term stability.

Install two #8 PAN head screws (1-inch or greater in length) into the mounted board, following these

guidelines and referring to Figure 29.

• Screws should be spaced horizontally, approximately 5 inches apart. Find exact positioning by using

the location of the two keyed insets on the bottom of the unit as a guide.

• Screws should be horizontally level with each other.

• Leave approximately 1/4-inch of the screws protruding from the board to allow the heads of the screws

to slide into place in the unit’s keyed insets.

Slide the keyed insets on the bottom of the unit’s chassis securely onto the screws.

Proceed to the steps given in Supplying Power to the Unit on page 69.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 89 90

Sin comentarios

ADTRAN NetVanta 3000 Series Guía de instalación Pagina 64