ADTRAN TRACER 6000 SERIES Guía para resolver problemas descargar pdf (Pagina 63)

TRACER 6000 Series Integrated System Manual Section 5 User Interface Guide

> RF LINK CONFIGURATION

Figure 5 shows the TRACER 64x0 RF Link Configuration menu page, which contains the transmit and

receive power settings and band plan configuration for both the local and remote units.

Figure 5. RF Link Configuration

> RF LINK CONFIGURATION > RX POWER

Displays the real-time receiver levels (for both the local and remote units) in dBm and a visual

approximation using a series of symbols (

#). The more symbols (#) displayed, the stronger the signal.

Real-time receiver levels are displayed within ±5 dBm accuracy and can vary with extreme temperatures.

If the link is down in either direction and remote end data is unavailable,

DATA NOT AVAILABLE displays in

place of the symbols (

#). This parameter is display only.

> RF LINK CONFIGURATION > TX POWER

Allows the transmitter levels (for both the local and remote units) to be adjusted. The current transmitter

level is displayed in dBm or a visual approximation using a series of symbols (

#). The more symbols (#)

displayed, the stronger the signal. Real-time receiver levels are displayed within ±1 dBm accuracy. If the

link is down and remote end data is unavailable,

DATA NOT AVAILABLE displays in place of the symbols (#).

Pressing (+) on this field sets the

TX POWER to full strength; pressing (-) reduces the TX POWER to the

minimum.

Reducing the transmitter power of the remote TRACER 64x0 could cause the RF link to

drop, requiring a technician to increase the transmit power by using the menu system at

the remote site.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 131 132

Sin comentarios

ADTRAN TRACER 6000 SERIES Guía para resolver problemas Pagina 63