ADTRAN TRACER 5045 Manual de instrucciones descargar pdf (Pagina 45)

TRACER 5045 System Manual Section 5 User Interface Guide

>TRACER SYSTEM CONFIGURATION

Figure 4 shows the TRACER 5045 System Configuration menu page. System configuration parameters for

both the local and remote TRACER 5045 units are available through this menu page.

Figure 4. TRACER 5045 System Configuration

>TRACER SYSTEM CONFIGURATION > RX POWER

Displays the approximate receiver levels (for both the local and remote units) using a series of symbols (#).

The more symbols (

#) displayed, the stronger the signal. If the link is down and remote end data is

unavailable,

DATA NOT AVAILABLE displays in place of the symbols (#). This parameter is display only.

>TRACER SYSTEM CONFIGURATION > TX POWER

Allows the transmitter levels (for both the local and remote units) to be adjusted. The current transmitter

level is displayed using a series of symbols (

#). The more symbols (#) displayed, the stronger the signal. If

the link is down and remote end data is unavailable,

DATA NOT AVAILABLE displays in place of the symbols

(

#).

Press <1> from any menu in the TRACER 5045 VT100 menu structure to access the

TRACER System Configuration menu page.

Reducing the transmitter power of the remote TRACER 5045 could negatively impact the

TRACER RF link.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 55 56

Sin comentarios

ADTRAN TRACER 5045 Manual de instrucciones Pagina 45