ADTRAN Express 4100 Manual de usuario descargar pdf (Pagina 180)

Appendix F. Frame Relay Firmware Version

F-4 Express 4100/4110 User Manual 61200176L2-1

DLCI Mapping/IP Map

Write security: 3, Read security: 5

This menu represents the IP protocol mapping that is to take place for this

DLCI.

IP Map/Active

Write security: 3, Read security: 5

When this is set to Yes (def), the Express 4100/4110 will attempt to

transport IP packets for this DLCI. A setting of No means that no IP

traffic or route will be exchanged.

IP Map/IARP

Write security: 3, Read security: 5

When this is set to Yes (def), the Express 4100/4110 will send

Inverse ARP packets in order to determine the IP address on the

other end of the virtual circuit. If the IARP is responded to, a route

is placed in the IP route table. A setting of No means that the route

address is to be assigned statically using the IP Map/Far-End IP

Address parameter. The Express 4100/4110 will always respond to

Inverse ARP requests.

IP Map/Far-End IP Address

Write security: 3, Read security: 5

This is the IP address of the device on the other end of the virtual

circuit. When this DLCI becomes active, the Express 4100/4110 will

add a route in the IP routing table.

IP Map/IP Netmask

Write security: 3, Read security: 5

The IP network mask to apply to the Far-End IP Address and Link

IP Address is specified here.

IP Map/Link IP Address

Write security: 3, Read security: 5

The virtual circuit may require an IP address to be specified at this

DLCI interface. This is called a numbered interface. This address is

used by the Express 4100/4110 to respond to Inverse ARP requests.

If this IP address is left as 0.0.0.0, the link is treated as unnumbered

1 2 ... 175 176 177 178 179 180 181 182 183 184 185 ... 212 213

Sin comentarios

ADTRAN Express 4100 Manual de usuario Pagina 180