ADTRAN 4202023L2 Manual de usuario descargar pdf (Pagina 48)

Configure Network Interface Using a VT100 Terminal Smart 16e Shelf User Manual

Configure Network Interface Using a VT100 Terminal

To set up the Smart 16e Shelf to accept SLIP, async PPP, or Ethernet communication from a network

manager, perform the following steps:

1. Connect the terminal to the Smart 16e controller EIA-232 port. The terminal settings should match the

Smart 16e controller baud rate setting (i.e., 9600 bps, 8 data bits, no parity, and 1 stop bit).

2. Apply power to the Smart 16e controller card. Press Enter until the Login screen appears on the

terminal screen.

3. Go to the

ETHERNET CONFIGURATION menu.

4. Configure the following Smart 16e network interface settings: IP address, Subnet Mask, Gateway IP

address (if required), Trap Host IP address, GET community name, SET community name, and SNMP

Trap community name.

4. USING TELNET

The Smart 16e Shelf supports Telnet access, allowing remote access to the Smart 16e Shelf menu interface

by the network manager.

To access the Smart 16e Shelf menu interface, establish a Telnet session using the Smart 16e Shelf IP

address to open a device session. The Smart 16e Shelf’s Main menu will display. Configure or monitor the

Smart 16e Shelf devices as if they were locally connected to the shelf with a VT100 terminal. Close the

Telnet application according to the network manager’s instructions.

5. INTERPRETING ALARMS AND STATUS MESSAGES

The four character display on the controller card front panel (Figure 25 on page 49) provides status

information about the Smart16e Shelf and the data communication cards that are installed in the shelf. If

no alarm conditions exists,

SM16 appears on the display. If an alarm condition exists, the display will

alternate between

ALM and SM16. Pressing the MODE button on the front of the controller card will

display the source of the alarm. Table 4 on page 49 lists the alarm messages.

The

STATUS LED provides a status of the Smart 16e controller card. Table 5 on page 50 lists the LED

states and their meanings.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 54 55 56

Sin comentarios

ADTRAN 4202023L2 Manual de usuario Pagina 48